Before opening the electrical cover on the A/C unit, be sure to shut off all power to the compressor unit and the indoor furnace or air handler, and verify that it is off. Note that this may mean shutting off a circuit breaker that serves the furnace and air handler, and then, near the compressor, pulling out the disconnect block (or shutting off the 220-volt power) to the outdoor compressor.
When your furnace filter becomes dirty, dusty and clogged, you can expect some negative effects on your furnace efficiency and your indoor air quality. The forced air is supposed to get blown through the filter and the filter is supposed to trap any particles so they don’t end up in your air ducts and throughout the house. When the filter has trapped too many particles and it is clogged up, the air keeps blowing, but some of those trapped particles will end up in the system and your living space. Another effect is that the furnace has to work harder to get the same amount of air through that dirty filter, so your heating bills may go up.
Having a company looking out for all your heating and cooling needs shouldn’t mean that you’re stuck with any run-of-the-mill shop who cuts corners. Heating and cooling has been our excitement since 1962, and it’s evident in the work we provide to our customers. We’re committed to providing you the very greatest when it comes to all things HVAC, whether it’s service, maintenance or heating and cooling systems.

The contactor (relay) and start/run capacitor(s) (see illustration below) fail most often and are inexpensive. So it’s a safe bet to buy and install those parts right away, especially if your air conditioning service unit is older than five years. The condenser fan motor can also fail, but it runs about $150 — hold off buying that unless you’re sure that’s the culprit.

1 Be sure the thermostat is set to the proper setting (Heat if you’re calling for heat and the temperature you want the room to be). If the thermostat was replaced recently, the new thermostat may either be the wrong type (it must be specifically a heat pump thermostat) or it may have been wired improperly. A mistakenly wired thermostat can fry electronic components, preventing the heat pump from working properly.


Jacobs Heating and Air Conditioning is your trusted source for commercial and residential air conditioning and heating repair in the metro Portland, Beaverton and Vancouver, WA areas. We offer repair and maintenance services for major air conditioner brands including Carrier, Daikin, Venmar, Honeywell, Navien and Heat N Glo to keep you comfortable at home or work during the summer months.
As an Atlanta resident, you’re well aware that the weather in our area can go through extremes of both hot and cold throughout the year, taxing your heating and cooling system to its limits. You’ll likely encounter the need for repair or replacement at some point. If you need HVAC installation, HVAC maintenance, or HVAC service and repair, R.S. Andrews is the most trusted name in Atlanta.
YP - The Real Yellow PagesSM - helps you find the right local businesses to meet your specific needs. Search results are sorted by a combination of factors to give you a set of choices in response to your search criteria. These factors are similar to those you might use to determine which business to select from a local Yellow Pages directory, including proximity to where you are searching, expertise in the specific services or products you need, and comprehensive business information to help evaluate a business's suitability for you. “Preferred” listings, or those with featured website buttons, indicate YP advertisers who directly provide information about their businesses to help consumers make more informed buying decisions. YP advertisers receive higher placement in the default ordering of search results and may appear in sponsored listings on the top, side, or bottom of the search results page.
A heat pump is an appliance used to provide heating and cooling services in moderate climates. These pumps don't generate heat; instead, they move heat from one place to the next, and in so doing, they're able to heat and cool your home at a lower cost. Air-source heat pumps are the most commonly used models on the market. Other choices include water-source and geothermal heat pumps.
The most efficient heating system is going to be solar, because outside of the initial hardware costs, solar energy is free. Of course the downside is you might not live in an area with a lot of sunlight, which means you’ll need to compliment your solar power with other energy sources, like fuel or electricity, when solar power runs low. Wood stoves are the next most efficient, but you’ll need to  buy wood and make a fire every day. Gas is the next most efficient, especially when gas prices are low, but they tend to fluctuate during peak usage times of the year. For pure efficiency, solar is the way to go. Regardless of what system you choose, make sure to have the proper insulation in your house to maximize heat (or cold) retention.
In addition to installing new HVAC systems from scratch and repairing them day and night, we also care about your indoor air quality. After all, it’s not enough to think about temperature alone. You also have to consider the relative humidity of your space, as well as eliminating as many contaminants and pollutants as possible. That means installing a whole-house air purifier or UV air purifier, and possibly a dehumidifier or humidifier. What’s more, our technicians offer attic insulation and abatement services in Anaheim, CA and the surrounding areas. Call Home Comfort USA today to learn more about what we can do to improve the air that you and your family breathe every day!
No one wants to be stuck in the dead of summer with a broken air conditioner, or in the cold of winter with a broken furnace or boiler. That’s why we’re available any time of day to make your emergency heating and air conditioning repair and get your system up and running as quickly as possible. We’ll show up on time, in uniform and ready to make your HVAC repair right the first time.
You might guess it from the name: the heat exchanger is the part of your furnace that actually heats the air your blower motor pushes through the furnace. It consists of a chamber in which the heat energy produced by natural or propane gas is transferred to the forced air. At the same time, this part also includes a vent through which the gases themselves are safely removed from the unit and the air that enters your home. Because of these gases, a problem with your heat exchanger needs to be dealt with promptly. Over time, cracks in the exchanger can result in carbon monoxide leaks. Taking care of the problem once again means understanding the existence of a range: repairing your heat exchanger can cost as little as $100, but a full replacement may cost up to $1,200.
The cost to replace your entire unit is around $4,000. That expense can range from $2,500 to $5,900, depending on the type and brand of furnace you choose. Brands particularly have an impact on that price. A Goodman electric furnace, will only cost about $2,100 for the unit and labor. On the other hand, a Trane oil furnace may cost up to $9,000 all things considered. Our Furnace Installation Cost Guide can give you a better idea on both the general cost and the differences for brands like Amana, Bryant, Coleman, and others. The brand also plays into the repair cost for your furnace. Especially the prices of individual parts can change; a York heat exchanger, for example, can cost up to $1,900, while the same component from Heil will cost as little as $400.

Heating Repair

×