Read what our many satisfied customers say about Moncrief. We consistently receive 5-star reviews from both our commercial and residential customers. Moncrief's legacy of comfort and trust, as well as our great team and customer service are second to none. Contact us today to schedule an appointment or inquire about our Total Comfort Service Plan. Moncrief Heating & Air Conditioning is the company to provide the services you need in Roswell and Marietta. Call us at 404-350-2300.
It isn’t unusual for a heat pump to ice-up in really cold weather, but it’s defrost cycle should kick on periodically to melt the ice. If the condenser unit of the heat pump is frozen up and the defrost cycle doesn’t melt the ice, turn it off. Make sure none of the return-air registers are blocked, and check the filter to make sure it isn’t clogged. If there doesn’t seem to be a problem with air flow to the unit, see more information at Heat Pump Cold Weather Problems or call an HVAC service professional.
Replacing a capacitor is easy. Just take a photo of the wires before disconnecting anything (you may need a reference later on). Then discharge the stored energy in the old capacitor (Photo 4). Use needle-nose pliers to pluck one wire at a time from the old capacitor and snap it onto the corresponding tab of the new capacitor. The female crimp connectors should snap tightly onto the capacitor tabs. Wiggle each connector to see if it’s tight. If it’s not, remove the connector and bend the rounded edges of it so it makes a tighter fit on the tab. When you’ve swapped all the wires, secure the new capacitor (Photo 5).
The contactor (relay) and start/run capacitor(s) (see illustration below) fail most often and are inexpensive. So it’s a safe bet to buy and install those parts right away, especially if your air conditioning service unit is older than five years. The condenser fan motor can also fail, but it runs about $150 — hold off buying that unless you’re sure that’s the culprit.
If the unit isn't turning on, check on it outside to make sure the condenser is still running. It should be fully plugged in and the thermostat should be set. Lower the thermostat by a few more degrees than your typical setting. You should hear it power on after doing so. If that doesn't take care of the problem, check your fuse box. You could have a blown fuse or a tripped circuit that's causing the air conditioner to not turn on.
Many things can go wrong with your furnace, all of which should be repaired and examined by experienced professionals. Trust Randazzo Heating, Cooling, and Fireplaces to repair and help you maintain your furnace*. We value our customers and their decisions, so we will always be honest and explain the best possible solution for you. Contact us today so we can help you out! Click Here for our warranty policy.
Jacobs Heating and Air Conditioning is your trusted source for commercial and residential air conditioning and heating repair in the metro Portland, Beaverton and Vancouver, WA areas. We offer repair and maintenance services for major air conditioner brands including Carrier, Daikin, Venmar, Honeywell, Navien and Heat N Glo to keep you comfortable at home or work during the summer months.
Your furnace's flame sensor is essentially a safety mechanism. As a thin metallic rod in front of the flame inside the unit, it's sole purpose is to confirm that your gas valves only open when a flame actually exists to burn that gas. When the flame sensor stop working, on the other hand, gas leaks can occur. To repair your furnace's flame sensor, expect to spend between $80 and $250. Even a full replacement of this part typically does not go above that range.
Fresh-Aire UV is an innovation leader in the field of indoor air quality. Our award-winning UV light and carbon products fight mold, bacteria, viruses and odors in commercial and residential HVACR systems. Our products include Blue-Tube UV®, the world’s most popular germicidal UV light, the revolutionary APCO® PCO/carbon whole-house air purifier, and Mini UV the first UV light system designed specifically for mini-split AC systems.
We’ve earned a reputation across Portland and The Dalles for dedicated customer service. Consistently maintaining an A+ rating from the Better Business Bureau, Sky Heating & Air Conditioning meets higher standards of excellence through the little, important details that add up to a job well done. It starts with a friendly voice on the phone, and the immediate focus of our extensive resources on your requirements. From there, you can count on timely arrival, organized project management, careful cleanup, competitive pricing, and exemplary performance in every aspect of service. When you contact Sky Heating & Air Conditioning for HVAC service in The Dalles and Portland, OR, your project is always handled by a highly-trained professional, who will achieve your goals for efficiency, reliability, and sustainable home comfort.
We have strived extremely hard to become the premier HVAC repair & installation choice for the peole of Columbia, Maryland. We pride ourselves on being the first HVAC company in all of Maryland to be awarded with Factory Authorized status. We have also earned the Distinguished Dealer Award by the Carrier Corporation for our strong & consistent dedication to superior local heating and air conditioning work in addition to exceptional customer satisfaction.
Check the thermostat to see if the Fan switch has been turned on. If it has, turn it to OFF or to Auto. If it is set to OFF or Auto already, the heat pump’s limit switch needs to be adjusted. Call a heat pump repair technician to make the adjustment or, if you are handy with this type of repair, follow the instructions in your owner’s manual to reset the pointers on the fan side of the limit control. The lower pointer should be set to about 90 degrees F. and the upper one should be at about 115 degrees F.
Yes. You should expect to pay a diagnostic fee to cover the cost of the technician's visit, the diagnosis of your air conditioner's problem, and a quote for the repair options. You will be advised of the issue along with recommended options to correct it, which may include a system replacement if your unit is old or significantly damaged. If you decide to replace the system, the diagnostic fee will be credited toward your replacement purchase.
The main purpose of your furnace filter is to ensure that none of the additional materials your fans pull back into the unit - such as hair and dust - actually damage the furnace or its parts. In the process, it also improves air quality in your home. Some annual inspections will include changing and cleaning this part of the unit. That said, you can also clean or change your furnace filteryourself. Costs for new filters range based on brand, but tend to be around $30.