To reset a gas furnace, start by making sure the pilot light has been extinguished. Next, turn down the room thermostat to its coldest setting, and cut the furnace's power from your home's circuit breaker. Cut the main gas supply to the furnace, but make sure that the gas line that leads to the furnace pilot is on. Light a match, and use it to ignite the jet of the furnace's pilot flame. Then restore the furnace power and main gas supply, and press and hold the furnace reset button for roughly half a minute.
The time it takes to install an AC unit and the associated cost depends on the square footage of your home. Many homeowners spend between $3,677 to $7,151 for a contractor to put in a new central air system.A family with a 2,000-square-foot house that already has a forced-air heating unit can expect to pay $3,500 to $4,000 for a cooling system. If technicians don't need to make any changes to the duct-work, then the project should take them an average of two to three days.

In addition to providing repairs for A/C and HVAC systems, we can also repair almost any heating system. Just tell us what the trouble is and we will run the appropriate tests and checks to find out what needs doing to get your heating operational again. We use high-grade equipment and tools for every job we complete, helping to give you the top-quality results you’re looking for.
When you establish routine visits with Vredevoogd Heating & Cooling Grand Rapids MI, you can enhance the longevity of your HVAC system with our custom care. Our technicians are skilled at performing comprehensive inspections. We routinely spot small issues before they can turn into major repairs. By optimally maintaining your system, we can extend its life and ensure that it reliably meets your household’s heating and cooling needs. You can also join our Comfort Club! You can schedule routine appointments to service your system before the hot and cold seasons. If you discover a problem afterward, call us to provide you with immediate service. We can troubleshoot the problem in no time. We’ll give you an upfront estimate concerning cost, parts, and labor. There’s no guessing when it comes to our service and costs. Our techs will provide you with everything you need to know about their service from beginning to end of the job. We even have Financing Available.
At Horizon Services, we strive to provide all of our customers with the peace of mind that comes from knowing that you have a skilled team on-call for any AC emergencies that may arise. We have more than 300 fully stocked trucks ready to go at a moment's notice. Our Horizon technicians undergo rigorous training, including a mandatory 150 hours of training every year, to ensure that they're always up to date on the latest techniques and HVAC technology. Plus, we perform extensive background checks, including drug and criminal checks, on all of our employees so you don't have to worry about letting a stranger into your home when your AC breaks down in the middle of the night. When you're dealing with an air conditioning emergency, trust the experts at Horizon Services!
I just finished fixing some skylights on my parent's house. They had the bubble type that started leaking after the roof was resurfaced. After investigating it carefully, it became apparent that when the roof was resurfaced, the edges of the skylight were covered with a sealant. (To help prevent leaks perhaps?)The problem was that this coating sealed up the weep slots along the perimeter of the aluminum frame. These slots are key to proper operation of the skylight. The skylight dome isn't sealed to the aluminum frame. The frame is designed with channels that direct any water that manages to flow between the bubble and the frame back out through weep holes.Make sure those weep holes are clear! They can be blocked by dirt, ice, or a well-intentioned roofer.
YP - The Real Yellow PagesSM - helps you find the right local businesses to meet your specific needs. Search results are sorted by a combination of factors to give you a set of choices in response to your search criteria. These factors are similar to those you might use to determine which business to select from a local Yellow Pages directory, including proximity to where you are searching, expertise in the specific services or products you need, and comprehensive business information to help evaluate a business's suitability for you. “Preferred” listings, or those with featured website buttons, indicate YP advertisers who directly provide information about their businesses to help consumers make more informed buying decisions. YP advertisers receive higher placement in the default ordering of search results and may appear in sponsored listings on the top, side, or bottom of the search results page.
Have you noticed that your A/C isn’t working as well as it could be? Perhaps there is an unexplained noise coming from the unit, or it doesn’t keep your home at the correct temperature. In these circumstances, a competitively priced repair is vital. It’s unlikely the problem will resolve on its own, so if you suspect there’s an issue, one call to us is all it takes.
A contactor is a $25 mechanical relay that uses low-voltage power from the thermostat to switch 220-volt high-amperage current to the compressor and condenser fan. AC contactors can wear out and are at the top of the list of common air conditioning service failures. Even if your contactor is working, it pays to replace it every five years or so. Unscrew the old contactor before removing the wires. Then move the wires to the new unit (photo 6).
Restoring or replacing an aging unit can get expensive. Invest in a new model if your utility bills are rising and you notice uneven air flow and temperatures throughout your property. If one room is cooler than another, consider a total replacement. If the air conditioner is relatively new and still within its age range, it's more cost-effective to get a contractor to repair it.
If the air conditioner on your thermostat set low, and you aren't feeling cool air, it could be that debris is blocking the condenser. Check on your system outside and remove any tree branches or leaves from around it. Debris can easily obstruct air flow, so make sure the area around your air conditioning unit is clean and trimmed back. Make sure your filter is clean. A buildup of dirt and dust can cause poor air circulation.
Ductwork pinging or popping. If you hear a pinging or popping sound coming from metal ductwork, this may be caused by thermal expansion or by air blowing past a loose flap of metal. Track along the duct runs, listening for the sound. If you find it, make a small dent in the sheet metal to provide a more rigid surface that’s less likely to move as it heats and cools.
With colder weather on its way back to Waldorf, furnace and heating repair may not be the first thing you think about, but maybe it should be. Sure, it’s easy for us to sit here and tell you to schedule annual furnace service, but it’s only because we want to help you avoid a heating breakdown during the coldest day of the month in Waldorf. Day or night, our HVAC experts are here to make sure you have a comfortable home, and can help get your furnace back running in little time.
HVAC equipment is estimated to last about 15 to 20 years. Yet over the years, parts go out and need to be repaired. Heat sensors, exchangers, and ducts can become worn out. Air conditioning motors may need repairing from time to time. For repairs to your heating and air conditioning systems, and even general maintenance, let HomeAdvisor help. Enter your zip code and let us connect you with prescreened HVAC repair services near you.

Replacing a capacitor is easy. Just take a photo of the wires before disconnecting anything (you may need a reference later on). Then discharge the stored energy in the old capacitor (Photo 4). Use needle-nose pliers to pluck one wire at a time from the old capacitor and snap it onto the corresponding tab of the new capacitor. The female crimp connectors should snap tightly onto the capacitor tabs. Wiggle each connector to see if it’s tight. If it’s not, remove the connector and bend the rounded edges of it so it makes a tighter fit on the tab. When you’ve swapped all the wires, secure the new capacitor (Photo 5).
To clean your air conditioner drain, first shut off the power to your unit at both the thermostat and the breaker. Then remove the drain pan. If the pan is full of water, soak up the liquid with a few towels or rags or use a wet vacuum. You can use a solution of water and distilled vinegar, or substitute peroxide for the vinegar, to clean out the drain pipe. Let the pipe sit for a while in the solution and then put all the parts back in place. Once you start using your air conditioner on a regular basis, check it periodically to ensure condensation isn't building up.
Are you considering whether you need to replace your home’s central heating, ventilation, and air conditioning unit—commonly known as your HVAC system? As a general rule, if your existing HVAC system is more than 15 years old, it’s only a matter of time before it starts to cost more to maintain than it would to replace it with a new system. In addition to higher energy bills brought on by a system that can no longer function at peak efficiency, repair costs will also start to add up as parts are replaced and the ventilation system undergoes major overhauls.
"Mike and crew were very prompt, very neat, and they quickly remedied the issue with our AC. Others, have tried to sell us on more than we actually needed. Mike was very honest about NOT replacing unnecessary parts. Superior was NOT the low bid, but they were close to it, and provided a very pleasant experience for this homeowner! I recommend you give Mike the opportunity address your Heating/AC issues and you can see for yourself why he has 5 Stars on all his reviews! Thanks Mike!"
×