Having a company looking out for all your heating and cooling needs shouldn’t mean that you’re stuck with any run-of-the-mill shop who cuts corners. Heating and cooling has been our excitement since 1962, and it’s evident in the work we provide to our customers. We’re committed to providing you the very greatest when it comes to all things HVAC, whether it’s service, maintenance or heating and cooling systems.
Reinstall the access panel and disconnect block. Turn on the circuit breaker and furnace switch. Then set the thermostat to a lower temperature and wait for the AC to start (see “Be Patient at Startup,” below). The compressor should run and the condenser fan should spin. If the compressor starts but the fan doesn’t, the fan motor is most likely shot. Shut off the power and remove the screws around the condenser cover. Lift the cover and remove the fan blade and motor (photo 7). Reinstall the blade and secure the cover. Then repower the unit and see if the fan starts. If it doesn’t, you’ve given it your best shot—it’s time to call a pro.
You should also have air ducts cleaned after recent water contamination or water damage to prevent mold; after renovations or remodeling to ensure debris and dust didn’t settle in the vents and ducts; if you are having problems with allergies or asthma; or when you are moving into a newly purchased home, especially if the previous owners smoked or had pets. The National Air Duct Cleaners Association (NADCA) recommends getting your air ducts cleaned every three to five years, or every two to three years in regions where homeowners use their air conditioning and heater for many months of the year, while the EPA suggests homeowners have duct cleaning done as needed.
"Warren at Lighten Up came in on time and as scheduled. Loved working with him. He provided new lighting for our kitchen remodel and did a great job. He still needs to come back and hook everything up. Also Seth came in and did some plumbing work and repair that we did not even know needed repair. I highly recommend this company and look forward to working with them in the future"
Solar heating is a method where the sun’s energy is collected by panels and converted to reusable energy. The sunlight collected is converted to direct current (DC) by photovoltaic cells in the panels. Then an inverter converts the DC current into alternating current (AC) and the panels send that electricity out and into your home to power things like your TV, computer, game consoles, and air conditioner. The more sunlight you have access to, the more energy you can produce. In some areas, solar powered homeowners can sell or trade the excess power they have accumulated to local power companies.
Vredevoogd Heating & Cooling Grand Rapids MI routinely serves the areas of Grand Rapids, Wyoming, Lansing, Grandville, and Kalamazoo. We provide a comprehensive menu of HVAC services delivered by certified HVAC technicians who specialize in heating and cooling repair and installation. World-class customer service is a cornerstone of our business and we are committed to doing the job right the first time. We have a reputation for integrity and service excellence. By living up to our good name, we continue to build our customer base throughout the Michigan region and look forward to adding you to our service family. So if you are looking for a “heating & air company near me” in Grand Rapids, or a Furnace Repair Lansing, Furnace Repair Kalamazoo and more. Call today.
In order to make your everyday life easier and more enjoyable, Sky Heating & Air Conditioning specializes in state-of-the-art heating and cooling technology, partnering with Trane, Mitsubishi, and Waterfurnace. We bring you HVAC solutions that represent the best the industry has to offer, ensuring long-term performance and satisfaction. Whether you’re looking for the design/build of a new system, replacement, or hoping to cut costs and enhance convenience, we answer with proven products. Our qualified HVAC technicians help you determine the ideal solution for your exact requirements, and make sure you’re happy with every step of the process. From ductless HVAC to geothermal heating and cooling systems, we offer a wide selection of options and comprehensive services to answer any type of challenge. Call on Sky Heating & Air Conditioning and let us exceed your expectations today!
A number of other variables can influence your decision on whether to repair or replace your furnace, as well. In addition to cost and brand, consider the expected lifetime of your furnace. If it is more than 15 years old, it might make more sense to invest in a new unit even if it costs more than simply repairing the current problem. Long-term costs also play into the equation. For example, your new furnace may be more energy efficient than the current unit. Even though you will pay more for the actual installation, you might be able to make back your investment through lower energy bills. To make your decision, consult with a reliable professional on what to do. In inspecting your furnace, they will be able to make an informed recommendation that looks not just to the next year, but years into the future. That way, you can make the best possible decision for your home and budget long-term.
Interesting article but I feel you should give it more depth. When you write about foundations, you only mention poured concrete like there is no other type. Some houses have foundations made with brick, masonry block and less commonly stone. Same comment for roofing type. Never heard of a flat roof? Binoculars won't work for that type. Also, you should point out that the owner of a house can provide information that can't be directly observed like the age of a roof (but can be confirmed later with a home inspection).
Your furnace's flame sensor is essentially a safety mechanism. As a thin metallic rod in front of the flame inside the unit, it's sole purpose is to confirm that your gas valves only open when a flame actually exists to burn that gas. When the flame sensor stop working, on the other hand, gas leaks can occur. To repair your furnace's flame sensor, expect to spend between $80 and $250. Even a full replacement of this part typically does not go above that range.
If you need a furnace repaired or an air conditioner serviced, we'll send a local technician out to diagnose the specific problem and recommend solutions for you and your family. There will be a diagnostic fee for the visit, and any specific repairs will be an additional charge. If replacing your system is the best solution, the fee for the diagnosis will be credited toward the purchase and install of a new system.
Aurora residents are well aware that when the furnace goes out in their home, can be incredibly frustrating to get working again. At times, there are serious things that go wrong with a home that needs to get fixed very quickly. As far as the furnace goes, it needs to get repaired or fixed as soon as possible, which is why it’s good to know that our furnace repair company does furnace replacement in Aurora and also Aurora furnace repair, is prepared to help at any time. To learn more about our furnace and heating services, click HERE today!
With more than 100 years in the industry, Lennox has consistently delivered industry-leading innovation and technology while preserving high durability and reliability standards. The professionals at B & B Heating & Cooling help bring those standards to Florissant so that you can always maintain whole home comfort. If you’re searching for a new HVAC system or even if you just have a question about what we offer, give us a call at 314-838-9800 or set up an appointment with us online. We’d love to hear from you.
Zolie from Brother's came out and repaired a main drain leak that was hidden and has been ongoing. He presented me with some options and recommendations and did an amazing, thorough job repairing the problem with the least invasive option. We are very grateful for our new relationship with Brothers and thankful for the work done by Zolie. THANK YOU!
We’re located in Florissant and service the surrounding area, so feel free to swing by if you’re searching for a new furnace or want to set up an appointment to have one of our techs visit your home and help you figure out which system is ideal for your home. Schedule furnace repair or a furnace service appointment with B & B Heating & Cooling using our online scheduler, or if you’re in need of help a little more quickly, give us a call at 314-838-9800.
Ductwork pinging or popping. If you hear a pinging or popping sound coming from metal ductwork, this may be caused by thermal expansion or by air blowing past a loose flap of metal. Track along the duct runs, listening for the sound. If you find it, make a small dent in the sheet metal to provide a more rigid surface that’s less likely to move as it heats and cools.
The cost of a new furnace might make you balk at first thought, but with modern manufacturers offering an extremely diverse range of options with varying AFUE ratings, optional accessories, and more, there is a furnace to meet any budget! It’s just important that you work with the right service team and experts that will work with you rather than try to “sell” you.
At B & B Heating & Cooling, heating and cooling isn’t solely our job, it’s our passion. We’re dedicated to providing you with high quality HVAC service in Florissant. No matter the size of the problem or time of day, you can rely on us to get the job done properly. After all, B & B Heating & Cooling has been working in the community since 1985, bringing comfort to our customers right when they need it.
Advice you can count on – When you have an emergency, you are not always in the position of asking questions to determine if the repairs you are receiving are what you need. At Jennings, our NATE Certified technicians will walk you through the repairs and explain why you need them. You can trust that everyone on Jennings’ staff will give you honest advice.
The contactor (relay) and start/run capacitor(s) (see illustration below) fail most often and are inexpensive. So it’s a safe bet to buy and install those parts right away, especially if your air conditioning service unit is older than five years. The condenser fan motor can also fail, but it runs about $150 — hold off buying that unless you’re sure that’s the culprit.
Fresh-Aire UV is an innovation leader in the field of indoor air quality. Our award-winning UV light and carbon products fight mold, bacteria, viruses and odors in commercial and residential HVACR systems. Our products include Blue-Tube UV®, the world’s most popular germicidal UV light, the revolutionary APCO® PCO/carbon whole-house air purifier, and Mini UV the first UV light system designed specifically for mini-split AC systems.
If your furnace, boiler or heat pump stops working after regular business hours, don’t panic. Our NATE-Certified technicians are available for emergency service calls, even on holidays. Call our office, where you will always speak to a person, not a recording, and help will soon be on the way. We fix all makes and models of furnaces, heat pumps and boilers, and our technicians can provide the proper heating repair for most heating systems with a single service call.