You might guess it from the name: the heat exchanger is the part of your furnace that actually heats the air your blower motor pushes through the furnace. It consists of a chamber in which the heat energy produced by natural or propane gas is transferred to the forced air. At the same time, this part also includes a vent through which the gases themselves are safely removed from the unit and the air that enters your home. Because of these gases, a problem with your heat exchanger needs to be dealt with promptly. Over time, cracks in the exchanger can result in carbon monoxide leaks. Taking care of the problem once again means understanding the existence of a range: repairing your heat exchanger can cost as little as $100, but a full replacement may cost up to $1,200.
Excalibur Water Systems helps solve the water challenges around the globe with water solutions for any possible water concerns in: water hardness, filtration of any contaminant, bacteria removal and high purity water needs and also comes with a warranty of up to 20 years at no extra cost. The best warranty for the water treatment equipment industry.
Cut down on energy costs and prevent damage to your furnace by addressing a gas furnace that's overactive or short cycling. Besides the need for consistently comfortable temperatures, this issue could cause long-term safety issues to your home, making it very important to address. From a faulty thermostat to a dirty filter, there are several possible causes to investigate.
"Superior AC & Heat inspected my furnace on Monday and determine that I needed to replace the furnace. Since I was also desiring to add AC to my home, I decided to bundled both projects and get a new furnace and AC Unit together. The team arrive at my home Wednesday morning at 7:45 am; the new furnace was installed by 1:00 pm and they completed the AC Unit, tested it and cleaned up by 4:30 pm. Great work; I highly recommend them."
If you need a furnace repaired or an air conditioner serviced, we'll send a local technician out to diagnose the specific problem and recommend solutions for you and your family. There will be a diagnostic fee for the visit, and any specific repairs will be an additional charge. If replacing your system is the best solution, the fee for the diagnosis will be credited toward the purchase and install of a new system.
If you believe that the ac not working or you’re getting little or no cold air, check these three things first. Make sure all the registers in the house are wide open. Then be sure the furnace filter is clean. Then go outside and clean off the condenser coils (Photo 2). If several registers were closed or the filter was clogged, the reduced airflow could have caused the evaporator coil to ice up and stop cooling your home. If you’ve changed the filter and opened all the registers and you’re still not getting airflow at the registers, deice the A-coil. Move the thermostat mode switch from “Cooling” to “Off” and move the fan switch from “Auto” to “On.” Let the blower run for at least 30 minutes or until there’s good airflow at the registers. Then turn the AC back on to test it. If it works for the next 12 hours, you’ve solved the problem.
Today’s heaters are technological wonders that will keep you warm and save you money. Investing in an energy-efficient heating system can raise the value of your property, and the cost of installation will be realized on the amount you’ll save on utility bills. With Cool Care Heating & Air, you can count on proper sizing and a hassle-free installation process. The new unit may also qualify for energy-efficient incentives, and Cool Care Heating & Air offers periodic dealer rebates on select replacement systems. If your heating system is 10-15 years old, needs frequent repair work and isn’t keeping you as warm as it used to, it’s probably approaching the end of its lifespan. Replacing the unit before it dies altogether can save you time, trouble and money.

Furnace Repair

×