2 Be sure the heat pump is receiving power. The two circuit breakers that protect the electrical circuits providing power to the air handler and heat pump condenser may have tripped. Check both the main electrical panel and any subpanels that supply power to the unit. If either circuit breaker has tripped, reset it by flipping it to OFF and then to ON. If the circuit breaker trips again, there is probably a short in the electrical system providing power to the furnace. Call an electrical contractor (Go to HomeAdvisor).
The contactor (relay) and start/run capacitor(s) (see illustration below) fail most often and are inexpensive. So it’s a safe bet to buy and install those parts right away, especially if your air conditioning service unit is older than five years. The condenser fan motor can also fail, but it runs about $150 — hold off buying that unless you’re sure that’s the culprit.
To clean your air conditioner drain, first shut off the power to your unit at both the thermostat and the breaker. Then remove the drain pan. If the pan is full of water, soak up the liquid with a few towels or rags or use a wet vacuum. You can use a solution of water and distilled vinegar, or substitute peroxide for the vinegar, to clean out the drain pipe. Let the pipe sit for a while in the solution and then put all the parts back in place. Once you start using your air conditioner on a regular basis, check it periodically to ensure condensation isn't building up.
Let Fayette Furnace help you step up your home efficiency with a wide range of air conditioning and heating products, services and our skilled team of technicians. An employee owned company since 1920; we pride ourselves on continuing a longstanding tradition of honesty, professionalism and expertise. Call and ask about our service maintenance agreements to save money on maintenance and emergency calls.

If your home is not heated using forced air, chances are a boiler will make sure you stay warm during cold nights. A hot water system delivers hot water through a network of pipes that run to every room in your house. The heating effect gets maximized through radiators. The most common issues with hot water heating tend to be not be major, but small problems that add up over time. Mineral deposits within the water tank, a pilot light malfunction, or an issue with a radiator itself can require professional repair. On average, you will pay between $183 and $582 for these problems. The exact amount will depend on the exact problem, as described in our boiler repair cost guide.

A furnace flame sensor is a device that's found in the burner assembly of your home's furnace. This thin metal rod sits directly facing the furnace's flame stream, and it tells the furnace whether ignition has occurred once the gas valve has been opened. If the gas valve has been opened and the sensor fails to detect a flame, the furnace will automatically shut down.


The store scheduling was great - confirmed for an open date within minutes. My technician was thorough and patient in explaining and working through the resolve needed for my furnace problem. He was courteous and good-natured, which helped to calm my frazzled state over a unexpected HVAC repair. The tech took care in my home not to create or leave a mess. Finally, & more importantly, I felt that rate was fair and I didn't feel cheated at the end of it all. I was also pleased that I could put the expense on my Home Depot card. I'd rather not need it, but if I run into another problem, I would gladly use them again.

Heating Repair Company

×